Showroom

Hoe u een 5-tons spinkraan correct bedient

Bij het bedienen van een 5t spinkraan, the following steps should be followed to ensure safety and efficiency:

Check the condition of the equipment: Before operation, check the mechanical structure, electronic control system and hydraulic system of the spin-liftkraan to ensure that there is no obvious damage or abnormality. Verify that the parts such as the hook, steel cable and boom are not worn.

Environmental preparation: Confirm that there are no obstacles in the working area and the ground is suitable for the support of the spider lift crane. The ground must be firm and flat to support the weight of the crane and the weight it lifts.

Deploy the outriggers: Fully unfold and level its outriggers to ensure the stability of the equipment. Adjust the angle and length of the outriggers to achieve maximum stability.

Control system test: Use the remote control or the main control system to test the basic functions of the equipment. Including the extension and rotation of the boom and the lifting and lowering of the hook to ensure sensitive and reliable operation.

Load lifting: Hang the hook on the object to be lifted and ensure that the sling is firmly connected. Lift the object slowly, observe the stability of the mini-rupskraan, and avoid sudden acceleration or turning.

Smooth operation: Control the boom angle and hook height to keep the load stable. When rotating or shifting, avoid large changes in direction and excessive speed to prevent the equipment from becoming unbalanced.

Landing and finishing: Place the object in the designated position steadily, loosen the slings, and ensure that the load is securely placed. After completing the operation, retract the boom and legs and clean up the site.

Regular maintenance: After the operation is completed, check the mini-rupskraan for wear and tear, and perform maintenance and maintenance as required to extend the life of the equipment.

Remember to follow the specific instructions in the operating manual, avoid overloading, and always pay attention to the balance of the 5t spinkraan to ensure safe operation.